122) In layout work, a pencil should not be used to draw lines on metal because

It will wipe off easily

The line will be too wide for accurate work

The line will smudge and difficult to see

The lines will remain on metal even after good rubbing

Answer is:

The line will be too wide for accurate work

OFB Chargeman Mechanical Question Paper - 2014 with Answer Key

For more MCQ's Click Here

123) Swing diameter over bed as compared to that over carriage is

Less

Same

None of these

Answer is:

124) Centre used for holding hollow jobs on a lathe is

Half centre

Pipe centre

Square centre

Revolving centre

Answer is:

Pipe centre

125) Knurling is an operation of

Cutting smooth collars

Under cutting

Roughing the surface for hand grip

Enlarging hole size

Answer is:

Roughing the surface for hand grip

126) Operation of bevelling the extreme end of a work piece, is known as

Chamfering

Grooving

Counter sinking

Counter boring

Answer is:

Chamfering

Explanation:

Chamfering: Chamfering is the operation of beveling the extreme end of the work piece. The form tool used for taper turning may be used for this purpose. Chamfering is an essential operation after thread cutting so that the nut may pass freely on the threaded work piece.