In Hole basic system the size of the hole is made constant, different fits is obtained by varying shaft size.
13) In hole basic system
Answer is:
The size of the hole is made constant
Explanation:
Related Limits and Fits MCQ - Machinist(Set-1) with Answers
Answer is:
Produce the parts within the required permissible size error
Explanation:
It is impossible to make anything to an exact size, therefore, it is essential to allow a definite tolerance or permissible variation on every specified dimension. Hence Tolerance is given to the part size to produce the parts, within the required permissible size error.
Answer is:
IT01, IT0, IT1 to 16
Explanation:
As per BIS system of Limits and fits, there are 18 grades of tolerances represented by number symbols from IT01, IT0, IT1 to 16.
Answer is:
Lower deviation is -0.1 mm
Explanation:
The size of a component is given as 24 -0.1. In this -0.1 indicates Lower deviation which is -0.1 mm
Answer is:
may be easily replaced without rejection the assembly
Explanation:
In the assemblies obtained by using the system of Limits and fits, the damaged parts may be easily replaced without rejection the assembly.